• Color Surface correction
• Correct craters, pinholes, eye-fishes
• Good flow

• Can be used in all system of powder coatings.
• Dosage: 0.5-1.5%wt.

• Synergistic effect with leveling agent, in powder coating
• Correct imperfections in powder such as poor leveling, surface craters, orange peels, pinholes, fisheyes

• Can be used in all system of powder coatings.
• Dosage: 0.7-2%.

• It can help to reduce the film melt viscosity.
• W-1 advances the fluidity of the melt coatings.
• The dosage of W-1 is about 0.5-1.5%wt.

• An organic compound which is used for degassing in powder coating.
• Dosage is about 0.3-0.8% of whole formulation.

• Can be applied in all system powder coating.
• The dosage of XP103 is 1-3%.

• It’s widely used as a curing agent (cross-linker) for outdoor polyester powder coatings.
• high-temperature

• Suitable for outdoor powder coatings
• Good weather durability
• Characteristic of low toxicity, no irritant to skin

Difference between T105 & T105M:

• Contains a higher amount of degassing agent
• Less benzoin is needed in the formulation
• Provides a whiter surface with less yellowing than T105

• Is a kind of phenolic resin which can cure fast under low temperature.
• It Can react with normal epoxy resin.
• It Can react with normal epoxy resin.

• It is used as curing agent in pure epoxy powder coatings.
• It is characteristics of good adhesion.

• Can be used as hardener in high reactive epoxy resin powder coating and as accelerator in dicyandiamide or hybrid powder coating.

• Can be applied both in pure epoxy and hybrid powder coating.
• Gloss range from 5-10% in epoxy coating and 10-70% in Hybrid coatings.>
• Color & gloss stability under normal baking conditions.

• Can be applied in hybrid powder coating.
• Gloss range from 3-15%

• Is kind of composite matting agent.
• Gloss range from 15-50%

• Can be applied in HAA or TGIC powder coatings system.
• In HAA systems gloss level is less than 5% @°60 angel.
• In TGIC system, it’s less than 10%

• Is specially made for producing wrinkle powder coatings.
• It is mostly applied in Epoxy, Hybrid powder coatings systems.

• Hammer texture
• Suitable for powder coatings with pure epoxy and or hybrid
• The final design is subject to change by changing the dosage of the product.

• Is specially made for producing Sand-texture powder coatings.
• The dosage of SW301B is about 0.02-0.5% .
• Can be used in all system of powder coatings.

• Is specially made for producing Sand-texture powder coatings.
• The dosage of SW301C is about 0.5-1.0%.
• Can be used in all system of powder coatings.

• An organic compound which is used for degassing in powder coating.
• Dosage is 0.1-0.6%.

• Its used to adjust the conductivity of powder coating.
• DH103 can minimize the Faraday Effect and improve the coating ratio esp.
• Minimizes Faraday effect and improves coverage.
• There is no problem with yellowing.
• Dosage: 0.1-0.5% based on total amount.
• It does not contain any catalyst and improves flowability.

• Can be used in all system of powder coatings.
• Improve the electric charging property of the powder.
• Dosage: 1-4%.